|
|
用得ch341编程器，用xshell访问，可以看到跑内容，但无论怎么按回车就是不能出现输入命令的情况。
1 L! ]) D+ A" r6 X具体跑内容如下，求指导
" \+ k+ F+ o- M0 B' M% t6 b*** Warning - bad CRC, using default environment
+ U- ~, U4 a& @9 G0 J# S0 @4 J: s1 m" A: y1 [
MMC: for ssg ledsdhci@d8000: 0
; v! Z2 h1 v& G- x7 a5 M: hÿ** File not found boot/armada-3720-customer0-minifs.dtb **
% I1 z% h# v- B1 L+ [7 }12931 bytes read in 8 ms (1.5 MiB/s)
' t* k) d0 R% W, l8 H9 k12931 bytes read in 3 ms (4.1 MiB/s)
( f/ t1 H6 y% g, n6 c0 w/ l( yComphy-0: USB3_HOST0 5 Gbps p, [/ ~" q- w* Z% v7 a1 ~
Comphy-1: SGMII0 1.25 Gbps 7 U' Z+ M. z0 q( w6 E
Comphy-2: SATA0 6 Gbps 6 K- d! V/ |1 R% t& ]9 c# R5 J
gpio: pin GPIO23 (gpio 39) value is 1& p) o- |* s ?) i0 y5 d7 t' o3 e
** File not found boot/armada-3720-customer0-minifs.dtb **
; t; @) k |9 s& i12931 bytes read in 3 ms (4.1 MiB/s)
8 q( \: l& s8 M- p; }: x5 ]Enter Normal mode
# E2 P6 C- P& ]* u& s2 Y2 eSCSI: Hit any key to stop autoboot: 0 4 T2 r5 t- ^$ a8 [
gpio: pin GPIO221 (gpio 57) value is 0
7 D |' K2 } U3 [+ j8 n/ H; nÿÿ즰io: pin GPIO221 (gpio 57) value is 12 D1 ^. B0 I2 X' w+ d- F
gpio: pin GPIO20 (gpio 36) value is 1
, _) F$ g5 X- w' ` ~; p v# J; v! H |) L8 S# u
: w2 A2 Q/ ^* d1 Y; j
. `% O9 n* e, z6 c: `' j- P2 I( Z
|
|
|Archiver|手机版|小黑屋|矿渣社区
( 黔ICP备2024020525号-1 )
