试试这个脚本
感谢分享dddd
支持，下载备用
我来试试 我的灵不灵
本帖最后由 wifi之歌 于 2022-6-2 20:05 编辑
root@maopan:~# smartctl -a /dev/sda
smartctl 6.5 (build date Oct7 2021) (local build)
Copyright (C) 2002-16, Bruce Allen, Christian Franke, www.smartmontools.org
=== START OF INFORMATION SECTION ===
Model Family: Seagate Laptop HDD
Device Model: ST500LM021-1KJ152
Serial Number: W62BXE1T
LU WWN Device Id: 5 000c50 09b42c816
Firmware Version: 0002YXM1
User Capacity: 500,107,862,016 bytes
Sector Sizes: 512 bytes logical, 4096 bytes physical
Rotation Rate: 7200 rpm
Form Factor: 2.5 inches
Device is: In smartctl database
ATA Version is: ATA8-ACS T13/1699-D revision 4
SATA Version is:SATA 3.0, 6.0 Gb/s (current: 6.0 Gb/s)
Local Time is: Thu Jun2 19:37:36 2022 CST
SMART support is: Available - device has SMART capability.
SMART support is: Enabled
=== START OF READ SMART DATA SECTION ===
SMART overall-health self-assessment test result: PASSED
See vendor-specific Attribute list for marginal Attributes.
General SMART Values:
Offline data collection status:(0x82) Offline data collection activity
was completed without error.
Auto Offline Data Collection: Enabled.
Self-test execution status: ( 0) The previous self-test routine completed
without error or no self-test has ever
been run.
Total time to complete Offline
data collection: ( 0) seconds.
Offline data collection
capabilities: (0x5b) SMART execute Offline immediate.
Auto Offline data collection on/off support.
Suspend Offline collection upon new
command.
Offline surface scan supported.
Self-test supported.
No Conveyance Self-test supported.
Selective Self-test supported.
SMART capabilities: (0x0003) Saves SMART data before entering
power-saving mode.
Supports SMART auto save timer.
Error logging capability: (0x01) Error logging supported.
General Purpose Logging supported.
Short self-test routine
recommended polling time: ( 2) minutes.
Extended self-test routine
recommended polling time: (78) minutes.
SCT capabilities: (0x103d) SCT Status supported.
SCT Error Recovery Control supported.
SCT Feature Control supported.
SCT Data Table supported.
SMART Attributes Data Structure revision number: 10
Vendor Specific SMART Attributes with Thresholds:
ID# ATTRIBUTE_NAME FLAG VALUE WORST THRESH TYPE UPDATEDWHEN_FAILED RAW_VALUE
1 Raw_Read_Error_Rate 0x002f 119 100 006 Pre-failAlways - 229169640
3 Spin_Up_Time 0x0023 098 098 000 Pre-failAlways - 0
4 Start_Stop_Count 0x0032 100 100 000 Old_age Always - 123
5 Reallocated_Sector_Ct 0x0033 100 100 036 Pre-failAlways - 0
7 Seek_Error_Rate 0x002f 069 060 030 Pre-failAlways - 9159082
9 Power_On_Hours 0x0032 090 090 000 Old_age Always - 8847
10 Spin_Retry_Count 0x0033 100 100 097 Pre-failAlways - 0
12 Power_Cycle_Count 0x0032 100 100 000 Old_age Always - 119
183 Runtime_Bad_Block 0x0032 100 100 000 Old_age Always - 0
184 End-to-End_Error 0x0033 100 100 097 Pre-failAlways - 0
187 Reported_Uncorrect 0x0032 100 100 000 Old_age Always - 0
188 Command_Timeout 0x0032 100 100 000 Old_age Always - 0
189 High_Fly_Writes 0x003a 100 100 000 Old_age Always - 0
190 Airflow_Temperature_Cel 0x0022 064 045 045 Old_age Always In_the_past 36 (Min/Max 36/40)
191 G-Sense_Error_Rate 0x0032 100 100 000 Old_age Always - 10
192 Power-Off_Retract_Count 0x0022 100 100 000 Old_age Always - 22
193 Load_Cycle_Count 0x0032 100 100 000 Old_age Always - 506
194 Temperature_Celsius 0x0022 036 055 000 Old_age Always - 36 (0 18 0 0 0)
196 Reallocated_Event_Count 0x0032 100 100 000 Old_age Always - 0
197 Current_Pending_Sector 0x0032 100 100 000 Old_age Always - 0
198 Offline_Uncorrectable 0x0030 100 100 000 Old_age Offline - 0
199 UDMA_CRC_Error_Count 0x0032 200 200 000 Old_age Always - 0
254 Free_Fall_Sensor 0x0032 100 100 000 Old_age Always - 0
SMART Error Log Version: 1
No Errors Logged
SMART Self-test log structure revision number 1
NumTest_Description Status RemainingLifeTime(hours)LBA_of_first_error
# 1Short offline Completed without error 00% 8725 -
# 2Short offline Completed without error 00% 8175 -
# 3Short offline Completed without error 00% 7455 -
# 4Short offline Completed without error 00% 6712 -
# 5Short offline Completed without error 00% 5992 -
# 6Short offline Completed without error 00% 5248 -
# 7Short offline Completed without error 00% 4576 -
# 8Short offline Completed without error 00% 3834 -
# 9Short offline Completed without error 00% 3090 -
#10Short offline Completed without error 00% 2975 -
#11Short offline Completed without error 00% 2255 -
#12Short offline Completed without error 00% 1511 -
#13Short offline Completed without error 00% 769 -
#14Short offline Completed without error 00% 68 -
#15Short offline Completed without error 00% 26 -
#16Short offline Completed without error 00% 1 -
SMART Selective self-test log data structure revision number 1
SPANMIN_LBAMAX_LBACURRENT_TEST_STATUS
1 0 0Not_testing
2 0 0Not_testing
3 0 0Not_testing
4 0 0Not_testing
5 0 0Not_testing
Selective self-test flags (0x0):
After scanning selected spans, do NOT read-scan remainder of disk.
If Selective self-test is pending on power-up, resume after 0 minute delay.
root@maopan:~# cd /tmp/jioben
root@maopan:/tmp/jioben# bash ledfan.sh
ledfan.sh: line 23: [: -ge: unary operator expected
ledfan.sh: line 37: [: -ge: unary operator expected
ledfan.sh: line 51: [: -lt: unary operator expected
ledfan.sh: line 23: [: -ge: unary operator expected
ledfan.sh: line 37: [: -ge: unary operator expected
ledfan.sh: line 51: [: -lt: unary operator expected
搞不定 :'(
感谢大佬
感谢分享
来看看学习