|
|
用得ch341编程器，用xshell访问，可以看到跑内容，但无论怎么按回车就是不能出现输入命令的情况。
8 j5 a1 d( J% n$ P具体跑内容如下，求指导
( ~+ W/ x' \! ~. f; b/ l" v0 Z7 z" K*** Warning - bad CRC, using default environment
$ M( H) b8 S6 M$ V0 m
# b! F2 d! N3 w+ e! `3 H& IMMC: for ssg ledsdhci@d8000: 0
' Y3 z: I$ Z) |2 m, Mÿ** File not found boot/armada-3720-customer0-minifs.dtb **+ E- }( M1 M/ ]4 \4 S3 A/ N$ I
12931 bytes read in 8 ms (1.5 MiB/s)' t& f, C Q1 G8 o; q
12931 bytes read in 3 ms (4.1 MiB/s)+ V2 d2 o4 A; o% j! l8 B6 E
Comphy-0: USB3_HOST0 5 Gbps
7 r" h- ^9 x- M9 SComphy-1: SGMII0 1.25 Gbps 9 e/ ^& n! ^/ ]! @! t6 c
Comphy-2: SATA0 6 Gbps 0 u# H# P2 T1 b" @
gpio: pin GPIO23 (gpio 39) value is 1
4 t6 q4 h0 }) v/ K4 X; p/ D$ C** File not found boot/armada-3720-customer0-minifs.dtb **
e) }+ @7 V- F, Z% C, w) o12931 bytes read in 3 ms (4.1 MiB/s)
9 l2 m+ R# w- d1 \6 N+ \0 OEnter Normal mode( e: N/ a# V) r9 k* p! O/ v
SCSI: Hit any key to stop autoboot: 0
7 L. v5 @7 }" Y" k J' O% x" Q; pgpio: pin GPIO221 (gpio 57) value is 0
' P( a5 ^5 k- J' ~* Kÿÿ즰io: pin GPIO221 (gpio 57) value is 1
; n5 A1 z6 l7 j) n5 Y; ?2 vgpio: pin GPIO20 (gpio 36) value is 1
0 o4 x8 \, i! E4 A4 t, j/ k9 k- W' }1 w/ l; v) y5 o
7 p$ q+ K! Y" y7 E6 a8 f+ g6 I! D( @
|
|
|Archiver|小黑屋|矿渣社区
( 黔ICP备2024020525号-1 )
